Installation steps of rv awning

During the installation of the car sunshade, there should be no rainwater accumulation. At the same time, the suspension and continuation of the project depends on the degree of rainfall. Choose buildings with wind force no more than 4.During installation, pay full attention to wind speed and direction to avoid wind flutter. During the tensioning process, determine the batch tensioning sequence, measurement value, control the tensioning speed, and determine the over-tensioning value according to the nature of the material.

Before the rv awning of the utility model is unfolded, the splints shall be fixed, and the spacing between the splints shall not exceed 2m. The spacing between the splints shall be adjusted according to the span of the RV awning, and the splint bolts and nuts shall be tightened in place.

According to the requirements of construction organization design, the ridge cable and valley cable of sunshade shall be installed. When installing the rv awning, the temporary ridge and valley pressure rope should be used before installation. Under the action of wind load, in order to prevent the uncompleted RV sunshade from excessive shaking. Protective measures shall be taken for the completed part of the RV sunshade to prevent damage when it is completed or when it is close to the commencement of the project. Without effective protective measures, welding and cutting within 2 meters around the diaphragm is prohibited.